Table of Contents
Advertisement
5. XBUS SRAM Test
6. JBus-to-PCIE Bridge Tests:
7. PCIE Tests:
4.2.2
POST Diagnostic and Error Message Format
POST diagnostic and error messages are displayed on a console. The format of the
these messages is the following:
Core-ID:Strand-ID ERROR:
Core-ID:Strand-ID H/W under test = description
Core-ID:Strand-ID Repair Instruction
Core-ID:Strand-ID MSG = error-message-body
Core-ID:Strand-ID END_ERROR
The following is an example of a POST error message
TABLE 4-1
3:2>ERROR: TEST = L2-Cache Functional
3:2>H/W under test = Core l2 Cache
3:2>Repair Instructions: Replace items in order listed by 'H/W
under test' above.
3:2>MSG = No way found to match tag address 00000000.00600000,
state 3
3:2>END_ERROR
4.3
OpenBoot Firmware
The Solaris OS installed operates at different run levels. For a full description of run
levels, refer to the Solaris system administration documentation.
• Internal registers test JBus interrupts
• JBus interrupts
• PCI-E MSI Interrupts test
• PLX Interconnect test
• PCI DMA tests
• JBus-to-PCI-E loop-back test
• Verify PCI-E Bus configuration
• Verify VID/DIC registers for all onboard PCI device
• Verify link status of all onboard PCI-E channel
TEST = test-name
Chapter 4
Firmware and Blade Server Management
4-3
Advertisement
Table of Contents
