Table of Contents
Advertisement
■
show-devs
For a complete list of OpenBoot commands and more information about the
OpenBoot firmware, refer to the OpenBoot 4.x Command Reference Manual. An online
version of the manual is included with the OpenBoot Collection AnswerBook that
ships with Solaris software.
4.3.3.1
probe-ide Command
The probe-ide command communicates with all Integrated Drive Electronics (IDE)
devices connected to the IDE bus. This is the internal system bus for media devices
such as the DVD drive.
Caution – If you used the halt command or the Stop-A key sequence to reach the
ok prompt, issuing the probe-ide command can hang the system.
CODE EXAMPLE 4-2
CODE EXAMPLE 4-1
{0} ok probe-ide
4.3.3.2
show-devs Command
The show-devs command lists the hardware device paths for each device in the
firmware device tree.
CODE EXAMPLE 4-2
{o} ok show-devs
/pci@7c0
/pci@780
/cpu@17
4-6
Netra CP3060 Board User's Guide • April 2009
shows sample output from the probe-ide command.
probe-ide Command Output
Device 0
( Primary Master )
ATA Model: FUJITSU MHV2040BH
Device 1
( Primary Slave )
ATA Model:
Device 2
( Secondary Master )
Not Present
Device 3
( Secondary Slave )
Not Present
CODE EXAMPLE 4-2
show-devs Command Output
shows some sample output.
Advertisement
Table of Contents
