Table of Contents
Advertisement
2.3
Preparing for the Installation
Read the following subsections before starting to install these blade servers. In
addition, do the following:
1. Become familiar with the contents of the referenced documentation.
2. Verify that all listed hardware and software is available (see
Requirements" on page
3. Check power, thermal, environmental, and space requirements (see
"Checking Power, Thermal, Environmental, and Space Requirements" on
page
4. Verify that local area network (LAN) preparations are completed (see
Section 2.3.2, "Determining Local Network IP Addresses and Host Names" on
page
5. Ensure that the host names and their network IP addresses are allocated and
registered at the site.
2.3.1
Checking Power, Thermal, Environmental, and
Space Requirements
Verify that you meet the following requirements:
Your enclosure specifications support the sum of the specified maximum blade
■
server power loads. See
specifications.
Facility power loading specifications can support the rack or enclosure
■
requirements.
Your enclosure specifications support the cooling airflow requirements. The Sun
■
Netra CP3060 blade server fits a standard ATCA shelf or chassis. If your
installation requirements are different, contact your field application engineer.
1-11).
2-3).
2-4).
Section 5.3, "Power" on page 5-27
Section 1.5, "System
Section 2.3.1,
for blade server power
Chapter 2
Hardware Installation
2-3
Advertisement
Table of Contents
