Table of Contents
Advertisement
Caution – Always wear a grounded antistatic wrist strap when handling modules.
2. Place the Sun Netra CP3060 blade server on an antistatic mat, or on the blade
server's antistatic bag if you do not have a mat available.
3. For the DDR-2 DIMM you wish to remove, simultaneously pull both DDR-2
DIMM retainer clips outward from the slot.
4. Grasp the DDR-2 DIMM by the edges, and carefully pull it out of its connector.
Place it in an antistatic bag.
FIGURE 2-3
5. If you are replacing the module you removed with a new DDR-2 DIMM, install
it as described in
page
2.4.2
Installation of Optional Compact Flash Card
An optional IDE Compact Flash card can be installed on the Sun Netra CP3060 blade
server. The Compact Flash card is not hot-swappable and there is no access to the
card once the blade server is installed in an ATCA chassis.
Removing a DDR-2 DIMM Memory Module
Section 2.4.1.1, "Installing a DDR-2 DIMM Memory Module" on
2-7.
Chapter 2
Hardware Installation
2-9
Advertisement
Table of Contents
