Information About Hardware; Notes On The Use Of 200V Power Supply; Connecting An Sas Device With Multiple Sas Targets To Onboard External Sas Interface Not Supported - Sun Microsystems SPARC Enterprise M3000 Product Notes

2
C H A P T E R

Information About Hardware

This chapter describes the special instructions and the issues about the SPARC
Enterprise M3000 server hardware.
"Notes on the Use of 200V Power Supply" on page 11
■
"Connecting an SAS Device With Multiple SAS Targets to Onboard External SAS
■
Interface Not Supported" on page 11
"Hardware Documentation Updates" on page 12
■
"Power-off by Using the XSCF Command" on page 14
■

Notes on the Use of 200V Power Supply

For servers that have the B-type plug, confirm that a 15A overcurrent protection
device is available outside the server. If one is not available, prepare an external 15A
overcurrent protection that can be achieved by means of no-fuse breakers (NFBs) or
fuses. The B-type plug refers to plugs other than grounding-type ones with two
parallel blades, such as the NEMA L6-30, L6-20, L6-15, and L5-15.
Connecting an SAS Device With
Multiple SAS Targets to Onboard
External SAS Interface Not Supported
It is not supported to connect an SAS device containing multiple SAS targets to the
onboard external SAS interface. Instead, use a Sun StorageTek Host Bus Adaptor
(SG-XPCIE8SAS-E-Z). [6765239]
11