Table of Contents
Advertisement
FIGURE 1-5
Netra CP3060 blade server
(installed from front)
Note – When the RTM is used with the Sun Netra CP3060 blade server, shielded
cables are required for serial I/O ports. Unshielded cables can be used on Ethernet
ports to satisfy EMI compliance standards. The shields for all shielded cables must
be terminated on both ends.
The customer can order the Sun Netra CP3060 RTM, build a custom card, or buy
from an IHV. A minimal set of I/O must provide a boot path for the host board and
a path for console I/O to deliver commands and to read board and system status.
1-10
Netra CP3060 Board User's Guide • April 2009
Relationship of the Sun Netra CP3060 Blade Server, Midplane, and RTM
Zone 3
connectors
ATCA chassis midplane
Netra CP3060 RTM
(installed from rear)
Advertisement
Table of Contents
