Table of Contents
Advertisement
2
C H A P T E R
Hardware Installation
This chapter describes the hardware installation procedures for the Sun Netra
CP3060 blade server, and contains the following sections:
Section 2.1, "Equipment and Operator Safety" on page 2-1
■
Section 2.2, "Materials and Tools Required" on page 2-2
■
Section 2.3, "Preparing for the Installation" on page 2-3
■
Section 2.4, "Configuring the Blade Server Hardware" on page 2-5
■
Section 2.5, "Installing the Sun Netra CP3060 Blade Server" on page 2-11
■
Section 2.6, "Connecting External I/O Cables" on page 2-17
■
2.1
Equipment and Operator Safety
Refer to Important Safety Information for Sun Hardware Systems (816-7190) for general
safety information.
Read the safety statements specific to the Sun Netra CP3060 blade server carefully
before you install or remove any part of the system.
Caution – Depending on the particular chassis design, operations with open
equipment enclosures can expose the installer to hazardous voltages with a
consequent danger of electric shock. Ensure that line power to the equipment is
disconnected during operations that make high voltage conductors accessible.
The installer must be familiar with commonly accepted procedures for integrating
electronic systems and with the general practice of Sun systems integration and
administration. Although parts of these systems are designed for hot-swap
2-1
Advertisement
Table of Contents
