Using The Cli To Access Member Switches For Configuration Changes And Traffic Monitoring - HP ProCurve series 2500 Management And Configuration Manual

You would then execute this command in the "North Sea" switch's CLI to
remove the switch from the stack:
Using the CLI To Access Member Switches for Configuration
Changes and Traffic Monitoring
After a Candidate becomes a Member, you can use the telnet command from
the Commander to access the Member's CLI or console interface for the same
configuration and monitoring that you would do through a Telnet or direct-
connect access from a terminal.
Syntax: telnet <switch-number>
To find the switch number for the Member you want to access, execute the
show stack view
you wanted to configure a port trunk on the switch named "North Sea" in the
stack named "Big_Waters". Do do so you would go to the CLI for the
"Big_Waters" Commander and execute show stack view to find the switch
number for the "North Sea" switch:
The switch number
(SN) for the "North
Sea" switch is "3".
Figure 9-36. Example of a Stack Showing Switch Number (SN) Assignments
To access the "North Sea" console, you would then execute the following
command:
You would then see the CLI prompt for the "North Sea" switch, allowing you
to configure or monitor the switch as if you were directly connected to the
console.
where: unsigned integer is the switch number (
mander to each member (range:
command in the Commander's CLI. For example, suppose that
Configuring Advanced Features
HP ProCurve Stack Management
) assigned by the Com-
SN
- ).
1 15
telnet
9-45