Spanning Tree Protocol (Stp) - HP ProCurve series 2500 Management And Configuration Manual

Configuring Advanced Features

Spanning Tree Protocol (STP)

Spanning Tree Protocol (STP)

STP Features
Feature
viewing the STP configuration
enable/disable STP
reconfiguring general operation priority: 32768
reconfiguring per-port STP
monitoring STP
The switch uses the IEEE 802.1D Spanning Tree Protocol (STP), when
enabled, to ensure that only one path at a time is active between any two nodes
on the network. In networks where there is more than one physical path
between any two nodes, STP ensures a single active path between them by
blocking all redundant paths. Enabling STP is necessary in such networks
because having more than one path between a pair of nodes causes loops in
the network, which can result in duplication of messages, leading to a "broad-
cast storm" that can bring down the network.
N o t e
You should enable STP in any switch that is part of a redundant physical link
(loop topology). (It is recommended that you enable STP on all switches
belonging to a loop topology.) This topic is covered in more detail under "How
STP Operates" on page 9-108.
As recommended in the IEEE 802.1Q VLAN standard, the Switches 2512 and
2524 use single-instance STP; a single spanning tree is created to make sure
there are no network loops associated with any of the connections to the
switch, regardless of whether VLANs are configured on the switch. Thus, these
switches do not distinguish between VLANs when identifying redundant
physical links. If VLANs are configured on the switch, see "STP Operation with
802.1Q VLANs" on page 9-110.
9-102
Default Menu CLI
n/a page page
9-103 9-105
disabled page page
9-103 9-106
page page
max age: 20 s 9-103 9-106
hello time: 2 s
fwd. delay: 15 s
path cost: var page page
priority: 128 9-103 9-107
mode: norm
n/a page page
10-15 10-15
Web
—
page
9-108
n/a