Cli: Configuring Stp - HP ProCurve series 2500 Management And Configuration Manual

CLI: Configuring STP

STP Commands Used in This Section
show spanning-tree config
spanning-tree
forward-delay <4 - 30>
hello-time <1 - 10>
maximum-age <6 - 40>
priority <0 - 65535>
ethernet <port-list>
path-cost <1 - 65535>
priority <0 - 255>
mode <norm | fast>
show spanning tree
Viewing the Current STP Configuration. Regardless of whether STP is
disabled (the default), this command lists the switch's full STP configuration,
including general settings and port settings.
show spanning-tree configuration
Syntax:
Default: See figure 9-70, below.
In the default configuration, STP appears as shown here:
Figure 9-70. Example of the Default STP Configuration Listing
Below
page 9-106
page 9-106
page 9-106
page 9-106
page 9-106
page 9-107
page 9-107
page 9-107
page 9-107
See "Spanning Tree Protocol (STP) Information" on page 10-15
Configuring Advanced Features
Spanning Tree Protocol (STP)
9-105