HP ProCurve series 2500 Management And Configuration Manual page 255

Default: In this example,
the "VLAN-22" has been
defined, but no ports
have yet been assigned
to it. ("No" means the
port is not assigned to
that VLAN.)
Using GVRP? If you plan
on using GVRP, any
ports you don't want to
join should be changed
to "Forbid".
A port can be assigned
to several VLANs, but
only one of those
assignments can be
"Untagged".
Figure 9-48. Example of VLAN Port Assignment Screen
2.
N o t e
To change a port's VLAN assignment(s):
Press [E] (for Edit).
a.
b. Use the arrow keys to select a VLAN assignment you want to change.
Press the Space bar to make your assignment selection (No, Tagged,
c.
Untagged, or Forbid).
For GVRP Operation: If you enable GVRP on the switch, "No"
converts to "Auto", which allows the VLAN to dynamically join an
advertised VLAN that has the same VID. See "Per-Port Options for
Dynamic VLAN Advertising and Joining" on page 9-82.
Untagged VLANs: Only one untagged VLAN is allowed per port. Also,
there must be at least one VLAN assigned to each port. In the factory
default configuration, all ports are assigned to the default VLAN
(DEFAULT_VLAN).
For example, if you want ports 4 and 5 to belong to both DEFAULT_VLAN
and VLAN-22, and ports 6 and 7 to belong only to VLAN-22, you would use
the settings in figure 9-49. (This example assumes the default GVRP
setting—disabled—and that you do not plan to enable GVRP later.)
Configuring Advanced Features
Port-Based Virtual LANs (Static VLANs)
9-61