Cli: Viewing And Configuring Community Names; Listing Current Community Names And Values - HP ProCurve series 2500 Management And Configuration Manual

Configuring for Network Management Applications
SNMP Communities

CLI: Viewing and Configuring Community Names

Community Name Commands Used in This Section
show snmp-server [<community-string>]
snmp-server
[contact <contact-str>]
[location <location-str>]
[community <community-str>]
[host <community-str> <ip-addr>]
[enable traps <authentication>

Listing Current Community Names and Values

Listing Community Names. This command lists the data forcurrently con-
figured SNMP community names (along with trap receivers and the setting for
authentication traps — see "Trap Receivers and Authentication Traps" on
page 8-10).
Syntax:
This example lists the data for all communities in a switch; that is, both the
default "public" community name and another community named "red-team"
Default
Community and
Settings
Non-Default
Community and
Settings
Trap Receiver
Data (See page
8-10.)
Figure 8-3. Example of the SNMP Community Listing with Two Communities
To list the data for only one community, such as the "public" community, use
the above command with the community name included. For example:
8-8
[<none | debug | all | not-info | critical>]
show snmp-server [<community-string>]
below
page 8-9
page 8-9
page 8-9
page 8-9
page 8-12
page 8-12