Cli: Displaying Current Port Security Settings - HP ProCurve series 2500 Management And Configuration Manual

Using Passwords, Port Security, and Authorized IP Managers To Protect Against Unauthorized Access
Configuring and Monitoring Port Security

CLI: Displaying Current Port Security Settings

The CLI uses the same command to provide two types of port security listings:
I
I
Using the CLI To Display Port Security Settings.
Syntax:
Without port parameters,
for all ports on a switch. For example:
Figure 7-4. Example Port Security Listing (Ports 7 and 8 Show the Default Setting)
With port numbers included in the command, show port-security displays Learn
Mode, Address Limit, (alarm) Action, and Authorized Addresses for the spec-
ified ports on a switch. The following example lists the full port security
configuration for a single port:
7-16
All ports on the switch with their Learn Mode and (alarm) Action
Only the specified ports with their Learn Mode, Address Limit, (alarm)
Action, and Authorized Addresses
show port-security
show port-security <port number>
show port-security [<port number>-<port number]. . .[,<port number>]
show port-security
displays Operating Control settings