Cli: Configuring And Displaying Trap Receivers; Using The Cli To List Current Snmp Trap Receivers - HP ProCurve series 2500 Management And Configuration Manual

CLI: Configuring and Displaying Trap Receivers

Trap Receiver Commands Used in This Section
show snmp-server
snmp-server host
snmp-server enable traps authentication

Using the CLI To List Current SNMP Trap Receivers

This command lists the currently configured trap receivers and the setting for
authentication traps (along with the current SNMP community name data —
see "SNMP Communities" on page 8-6).
Syntax:
In the next example, the show snmp-server command shows that the switch
has been previously configured to send SNMP traps to management stations
belonging to the "public", "red-team", and "blue-team" communities.
Example of
Community
Name Data (See
page 8-6.)
Example of Trap
Receiver Data
Figure 8-4. Example of Show SNMP-Server Listing
<ip-addr> <community-name>
[none | all | non-info| critical | debug]
Configuring for Network Management Applications
Trap Receivers and Authentication Traps
below
page 8-12
page 8-12
Authentication
Trap Setting
8-11