Table of Contents
Advertisement
CDM-600L Satellite Modem
Remote Control
16.6.6
BUC Commands
Command
Arguments
Parameter
(Instruction
for Command
Type
Code and
or Response
Qualifier)
BUC Power
ODP=
1 byte, value
enable
of 0 or 1
BUC 10 MHz
ODR=
1 byte
Reference
BUC Low
ODL=
4 bytes
Current Limit
BUC High
ODH=
4 bytes
Current Limit
BUC Carrier
OOD=
5 bytes
Output Delay
BUC Address
OAD=
1 byte, value
of 1 to 15
BUC Output
OOP=
1 byte, value
Power Enable
of 0 or 1
Description of Arguments
to Query
Command or Query.
0=Disable BUC DC Power Supply
1=Enable BUC DC Power Supply
Command or Query.
Where x is either 0(OFF) or 1(ON).
Command or Query.
BUC Low Current Limit, a value between 0 and 4000mA, in
100mA increments.
Command or Query.
BUC High Current Limit, a value between 0 and 4000mA, in
100mA increments.
Command or Query.
Power-up delay for the BUC to warm-up prior to the TX Carrier
On, where
mm=minutes (0–20)
ss = seconds (0–59)
Command or Query.
BUC Address, in the form: xx, where xx is between 1 and 15.
Note: This command is only valid when the FSK and BUC power
are enabled.
Command or Query.
BUC Tx Carrier Output Power, either 0(OFF) or 1(ON).
Note: This command is only valid when the FSK and BUC power
are enabled.
Response to
Command
ODP=
ODP?
ODP*
ODP#
ODR=
ODR?
ODR*
ODR#
ODL=
ODL?
ODL*
ODL#
ODH=
ODH?
ODH*
ODH#
OOD=
OOD?
OOD*
OOD#
OAD=
OAD?
OAD*
OAD#
OOP=
OOP?
OOP*
OOP#
16–36
Revision 2
MN/CDM600L.IOM
Query
(Instruction
Response to Query
Code and
Qualifier)
ODP?
ODP=x
(see description of
arguments)
ODR?
ODR=x
(see description of
arguments)
ODL?
ODL=xxxx
(see description of
arguments)
ODH?
ODH=xxxx
(see description of
arguments)
OOD?
OOD=mm:ss
(see description of
arguments)
OAD?
OAD=xx
(see description of
arguments)
OOP?
OOP=x
(see description of
arguments)
Advertisement
Table of Contents
