Telecommunications Terminal Equipment Directive; Emc (Electromagnetic Compatibility) - Comtech EF Data CDM-600L Installation And Operation Manual

CDM-600L Satellite Modem
Preface
using a separate wire to the ground stud on the back of the chassis. Since the DC input is
isolated, either the positive or the negative side of the DC input may be common with
local ground. Labeling on the back of the chassis indicates the positive and negative
terminals of the input power socket.
The modem is supplied with a 2-wire power cable (CEFD part number CA/WR10327-1)
with one end terminated with a connector that mates with the modem input power socket.
Positive DC input is on the red wire, while negative DC input is on the black wire. The
DC input connector is Molex PN 03-12-1026 with Molex PN 08-12-1222 pins.

Telecommunications Terminal Equipment Directive

In accordance with the Telecommunications Terminal Equipment Directive 91/263/EEC,
this equipment should not be directly connected to the Public Telecommunications
Network.

EMC (Electromagnetic Compatibility)

In accordance with European Directive 89/336/EEC, the CDM-600L Modem has been
shown, by independent testing, to comply with the following standards:
Emissions:
Immunity:
Additionally, the CDM-600L has been shown to comply with the following standards:
IMPORTANT
EN 55022 Class B - Limits and methods of measurement of radio
interference characteristics of Information Technology Equipment.
(Also tested to FCC Part 15 Class B)
EN 50082 Part 1 - Generic immunity standard, Part 1: Domestic,
commercial and light industrial environment.
EN 61000-3-2
EN 61000-3-3
EN 61000-4-2
EN 61000-4-4
EN 61000-4-5
EN 61000-4-6
EN 61000-4-8
EN 61000-4-9
EN 61000-4-11
EN 61000-4-13
Harmonic Currents Emission
Voltage Fluctuations and Flicker
ESD Immunity
EFT Burst Immunity
Surge Immunity
RF Conducted Immunity
Power frequency Magnetic Field Immunity
Pulse Magnetic Field Immunity
Voltage Dips, Interruptions, and Variations Immunity
Immunity to Harmonics
In order that the Modem continues to comply with these
standards, observe the following instructions:
xii
Revision 2
MN/CDM600.IOM