Table of Contents
Advertisement
CDM-600L Satellite Modem
Remote Control
Command
Arguments
(Instruction
for Command
Parameter
Type
Code and
or Response
Qualifier)
BUC Power
OPL=
1 byte, value
Leveling
of 0 or 1
Enable
BUC Target
OTP=
4 bytes
Power
BUC Current
N/A
4 bytes
BUC Voltage
N/A
4 bytes
BUC Output
N/A
4 bytes
Power Level
BUC
N/A
4 bytes
Temperature
Description of Arguments
to Query
Command or Query.
Indicates BUC Power Leveling, either 0 (Leveling Off) or 1
(Leveling On).
Note: This command is only valid when the FSK and BUC power
are enabled.
Query only.
Target level for leveling control of output power (negative sign is
assumed). Command is only used between CDM-600L units in a
1:1 system.
Format: xx.x
Range: 0 to -40 dBm
Query only.
Indicates the value of the BUC Current, in the form: xxxx, where
xxxx is between 0 and 9999, units mA.
If not available, response is 0000.
Query only.
Indicates the value of the BUC Voltage, in the form: xx.x, where
xx.x is between 0 and 64.0, units in volts.
Query only.
BUC Output Power Level, where xx.x is the value in dBm.
Example: OOL=37.4
Returns xxxx when FSK and BUC power are not enabled.
Query only.
BUC temperature, in the form: sxxx, where
s = sign
xxx = number
Note: This query is only valid when the FSK and BUC power are
turned On.
Response to
Command
OPL=
OPL?
OPL*
OPL#
OTP=
OTP?
OTP*
OTP#
N/A
N/A
N/A
N/A
16–37
Revision 2
MN/CDM600L.IOM
Query
(Instruction
Response to Query
Code and
Qualifier)
OPL?
OPL=x
(see description of
arguments)
OTP?
OTP=xx.x
(see description of
arguments)
ODC?
ODC=xxxx
(see description of
arguments)
ODV?
ODV=xx.x
(see description of
arguments)
OOL?
OOL=xx.x
(see description of
arguments)
ODT?
ODT=sxxx
(see description of
arguments)
Advertisement
Table of Contents
