Table of Contents
Advertisement
CDM-600L Satellite Modem
Introduction
simplifies software upgrading, and updates can now be sent via the Internet, e-mail, or on
disk. The upgrade can be performed without opening the unit by simply connecting the
modem to the serial port of a computer. Refer to Chapter 13 for addition information.
1.1.3
Verification
The unit includes many test modes and loopbacks for rapid verification of the correct
functioning of the unit. Of particular note is the IF loopback, which permits the user to
perform a quick diagnostic test without having to disturb external cabling. During the
loopback, all of the receive configuration parameters are temporarily changed to match
those of the transmit side, and an internal RF switch connects the modulator output to the
demodulator input. When normal operation is again selected, all of the previous values
are restored.
1.1.4
Data Interfaces
The CDM-600L includes, as standard, a universal data interface that eliminates the need
to exchange interface cards for different applications. The interfaces offered include:
•
•
•
•
•
•
•
•
•
•
1.2
Major Assemblies
Assembly
PL/9662-1
PL/9662-2
PL/9662-3
PL/9662-4
AS/0463
AS/9436
PL/10341-1
PL/9076-1
PL/9640-1
RS-422 (RS-530) DCE (at rates up to 10 Mbps)
X.21 DTE and DCE (at rates up to 10 Mbps)
V.35 DCE (at rates up to 10 Mbps)
Synchronous RS-232 DCE (at rates up to 300 kbps)
G.703 E1, balanced and unbalanced
G.703 T1, balanced
G.703 E2, balanced and unbalanced
G.703 T2, balanced
Serial LVDS (at rates up to 20 Mbps)
Dual Audio, 600Ω (produces a single 64 kbps IBS data stream)
Description
0.02 PPM Reference Modem Card – 75Ω receive Type F
1 PPM Reference Modem Card – 75Ω receive Type F
0.02 PPM Reference Modem Card – 50Ω receive Type N
1 PPM Reference Modem Card – 50Ω receive Type N
Turbo Codec – low rate
Turbo Codec – high rate
LDPC and High RateTurbo Codec
Baseband Framing Card
Chassis
1–3
Revision 2
MN/CDM600L.IOM
Advertisement
Table of Contents
