CDM-600L Satellite Modem
Remote Control
16.6
Remote Commands
The following remote commands are arranged in the following order:
•
•
•
•
•
•
•
TX Priority System = TIT (Highest priority) , TFM, TFT, TMD, TCR, and TDR
(Lowest Priority), indicated by shading. Any change to a higher priority parameter can
override any of the parameters of lower priority.
RX Priority System = RIT (Highest priority) , RFM, RFT, RMD, RCR, and RDR
(Lowest Priority), indicated by shading. Any change to a higher priority parameter can
override any of the parameters of lower priority.
Exception: Select DROP or INSERT mode using TFM or RFM (Framing type) which is
highest priority .
Note: The following codes are used in the 'Response to Command' column:
Transmit (TX) Commands
Receive (RX) Commands
Unit Commands
Query Commands
Bulk Commands
BUC Commands
LNB Commands
=
Message ok
?
Received ok, but invalid arguments found
*
Message ok, but not permitted in current mode
#
Message ok, but unit is not in Remote mode
~
Time out of an EDMAC pass-through message
16–6
Revision 2
MN/CDM600L.IOM