Connecting To A Network With A Cat5 Ethernet Connector; Figure 2-5 Wiring Connections Shown On Board - Honeywell HD54IP User Manual

Document 800-09311V3 Rev A
07/2013
Performance Series Rugged Day/Night H.264 IP Dome Camera User Guide
Figure 2-5 Wiring Connections Shown on Board
Caution For secure installations, surface-mounted cables should be protected
by plastic or metal cable covers.
Note Connect power either from a 24 V AC source or a CAT5 Ethernet connector
(PoE). It is recommended that you do not connect both power sources at the
same time.

Connecting to a Network with a CAT5 Ethernet Connector

The main video connection for your camera is made through the Ethernet network
connection. Connect the CAT5 Ethernet connector (see
network using an Ethernet (10Base T, 100Base TX) cable.
Note You can connect your camera to a network or connect it directly to a PC or
laptop using a crossover cable between the camera and the PC or laptop.
RJ45 Ethernet Connector
(see Connecting to a Network with
a CAT5 Ethernet Connector, page
25)
This is also the connection for
Power over Ethernet (PoE 802.3af)
Power 24 V AC
Local video out
Figure 2-5 on page 25) to your
25