Dsp Configurator Toolbar Menus - Extron electronics DMP 64 User Manual

DSP Configurator Toolbar Menus

The DSP Configurator contains the following structural menus, arranged horizontally
below the title bar:
File
NOTE:
mode.
• New — Discards the current DSP configuration (after prompting to
save any changes) and opens a blank configuration file.
• Open — Loads and activates a previously saved DSP
configuration file.
• Save — Saves all changes to the current DSP configuration file
under the current file name. If the file has not previously been
saved, prompts for a file name.
• Save As — Saves all changes to the current DSP configuration
file under a new file name.
• Backup — Transfers all partial presets plus the current configuration to a DSP
configuration file within the DSP Configurator program.
• Recent Files — Opens a list of recently opened or saved DSP configuration files.
• Exit — Closes the DSP Configurator Program.
Edit
• Cut — Removes all parameters of a selected
processor block or set of selected blocks to the
clipboard. If not followed by a
different block, the parameters are restored.
NOTE: Processor blocks are not removed from the processor stream after a
Cut
Processor blocks and their parameters can be pasted only into another block of
the same type. For example, the input 1 filter block and all of its parameters can
be copied to the input 2 filter block but not to the input 1 delay block.
• Copy — Copies all of the parameters of a selected processor block, gain block, or
set of selected blocks to the clipboard.
• Paste — Inserts processor blocks and their parameters from the clipboard into the
selected location.
, , and
New Open Recent Files
Paste
and a subsequent
Paste
are unavailable in Live
command to a
operation. Only the parameters are moved.
DMP 64 • Software Control 22