Extron electronics DMP 64 User Manual page 86

8. To push all of the DSP Configurator gain and processor block adjustments
(configuration), and all presets to the DMP 64, proceed to step 9.
To tailor the push (push only the configuration, only the presets, or the configuration
and selected presets), click the
a. Select the
Custom
b. Select the desired checkboxes:
Push Configuration
NOTE:
Push Configuration
block settings. It does not include partial presets.
c. If was clicked in step 8b, click
Push Presets
to choose specific presets.
Selected
If was clicked, click OK and proceed to step 8d.
Selected
•
If was clicked (equivalent to a standard push), click OK and proceed to
All
•
step 9.
d. If was clicked in step 8c, the Synchronize with Device dialog box (7b)
Selected
reappears. Click OK. The presets dialog box appears.
e. Select the desired partial presets to push by clicking the appropriate checkbox.
f. Click OK. — Proceed to step 10.
9. Click OK. The DSP Configurator program is connected live to the device, the
processors and presets are pushed or pulled as selected, and the selection of Live
mode is complete.
10. If changes were made to the DSP parameters (including mix-point, gain or processor
blocks) since the last file save, the DSP Configurator prompts to save the file. Click
Yes or No.
If a password is required and not entered or if an incorrect password is entered, the
program prompts for the password.
The configuration and presets are uploaded to the DMP 64.
button and proceed to step 8a.
Advanced
radio button.
Push Configuration
is the only box checked, click
includes all mix-point, gain, and processor
, or both. If
Push Presets
and proceed to step 9.
OK
to select all presets or
All
DMP 64 • Software Control 80