Primary Mix Matrix - Extron electronics DMP 64 User Manual

Primary Mix Matrix

The DSP architecture contains a primary mix matrix that connects the mic/line inputs
and virtual bus returns to the line outputs. The DSP Configurator user interface provides
control of the primary mix matrix, used to set mix levels from the post processing inputs
and post processing virtual returns to each line output bus. Each mic/line input and
virtual bus return is connected to a mix-point for each of the four line outputs. In general,
mix levels are set relative to each other, achieving a desired blend of input signals at an
optimal output level, close to, but not exceeding 0 dBFS at the line output volume block
level meter (while accounting for processing that can occur in the line output signal chain).
Shown below is a block diagram of the DMP 64 represented in the DSP Configurator, with
a red box indicating the primary mix matrix.
NOTE: Although the virtual bus send and return lines, A to D, are shown as end
From the primary mix matrix, any or all of the six inputs can be routed to any or all of the
four outputs. Any or all of the six inputs can also be routed to the secondary mix matrix.
Inputs
1 Mic/Line Input 1
2 Mic/Line Input 2
3 Mic/Line Input 3
4 Mic/Line Input 4
5 Mic/Line Input 5
6 Mic/Line Input 6
Virtual Bus Return
Figure 40.
points in the block diagram below, they are connected A to A, B to B, C to C and
D to D.
Primary Mix Matrix
Main Mix-Points
GAIN
FLT FBS DYN DYN
GAIN FLT FBS DYN DYN
GAIN FLT FBS DYN DYN
GAIN
FLT FBS DYN DYN
GAIN
FLT FBS DYN DYN
GAIN
FLT FBS DYN DYN
A
FLT DYN LOUD GAIN
B
FLT DYN LOUD GAIN
C
FLT DYN LOUD GAIN
D
FLT DYN LOUD GAIN
Primary Mix Matrix (outlined in red)
GAIN
DLY DUCK
DLY GAIN
DUCK
DLY GAIN
DUCK
GAIN
DLY DUCK
GAIN
DLY DUCK
GAIN
DLY DUCK
Virtual Return
Mix-Points
DMP 64 • Software Control
1
TRIM LOUD DLY FLT DYN VOL
2
TRIM DLY FLT DYN VOL
LOUD
TRIM DLY FLT DYN VOL 3
LOUD
4
TRIM DLY FLT DYN VOL
LOUD
Outputs
A B C D
Virtual Bus Send
61