Sis Programming And Control; Connection Options - Extron electronics DMP 64 User Manual

SIS Programming
and Control
This section describes SIS programming and control of the DMP 64, including:
•
•
•
•
•

Connection Options

The DMP 64 Digital Matrix Processor can be remotely connected via a host computer or
other device (such as a control system) attached to the rear panel RS-232 port or LAN
port, or the front panel USB Config port.
The DMP 64 can be set up and controlled using SIS commands, embedded web pages,
or DSP Configurator software. See
and details on the configuration and control port connections. For information on
DSP Configurator, see
see
SIS commands can be executed using the Extron Electronics DataViewer program, found
on the Software Products DVD included with the product.
DMP 64 RS-232 protocol:
• 38400 baud
• 8 data bits
NOTE: Both rear panel configuration ports require 38400 baud communication. This
For additional details on connecting the RS-232 port, see
USB port details:
The Extron USB driver must be installed before the USB port can be used (see
USB Driver
LAN port defaults:
gateway IP address: 0.0.0.0
Connection Options
Host-to-device Communications
Command and Response Table for Basic SIS Commands
Command and Response Tables for DSP SIS Commands
Special Characters
DMP Software
HTML Operation on page 120.
• no parity
• no flow contro
is a higher speed than many other Extron products use. When using HyperTerminal
or a similar application, make sure the PC or control system connected to these
ports is set for 38400 baud.
on page 17).
DMP 64 IP address: 192.168.254.254
subnet mask: 255.255.0.0
DHCP: off
Installation on page 5 for pin assignments
on page 14, and for the embedded web pages,
• 1 stop bit
RS-232 Ports
DMP 64 • SIS Programming and Control
on page 93.
Install the
92