Extron electronics DMP 64 User Manual page 139

Mute and Unmute Inputs and Outputs
Pressing the button toggles mute on or off. When muted, the
Mute
displays Muted. When unmuted it returns to gray and displays Mute.
Mute and umute as follows:
1. Next to the desired input or output press the
turns red) or off (button is gray ).
2. Repeat for each input and output.
Mute and Unmute the Mixer-points
The HTML mixer does not include control for the virtual bus send and receive mixer. When
a mixer-point is muted (default) no signal passes. When unmuted, the signal passes from
selected input to the selected output.
Mute and unmute the mixer-points as follows:
1. Click the desired input and output combination. The selected mix-point turns green.
Mic 1 to Output 4 is shown selected (see figure 72).
Figure 72. Output Selection Drop Box
2. Click the button to either toggle mute on or off.
Mute
3. Repeat steps 1 and 2 for each I/O combination.
Change the Mic Mix Audio Level
To change the mix-point audio input level:
1. Click the desired input and output combination. The selected mix-point turns green.
Mic 1 to Output 4 is shown selected (see figure 72).
2. Click the
Mic Mix Audio Level
+ and - boxes increment the level up or down one step.
3. Click and drag the slider or click the scroll up
the desired audio level is visible.
4. Click the desired gain or attenuation value. The range is -35 to +25 dB.
5. Repeat steps 1 through 3 for each mix-point.
button to toggle mute on (button
Mute
drop-down box. A list box appears. Alternately the
button or scroll down
DMP 64 • HTML Operation
button is red and
Mute
button until
133