Extron electronics DMP 64 User Manual page 40

Figure 25. Filter Dialog Box, Filter Not Bypassed
Above the graph, each filter has a "handle" (circled in red above for the parametric
EQ filter) placed directly above the cutoff or center frequency. The handle number
corresponds to the filter number (also outlined in red). Clicking a handle or clicking the
table row brings focus to that filter.
changes the cutoff or center frequency to a new position on the x axis.
The table below shows each filter type with default parameter settings. The table
immediately following shows the range for each parameter.
Type Frequency
Parametric 1000.0 Hz
High Pass 100.0 Hz
Low Pass 10000.0 Hz
Bass (Tone) 100.0 Hz
Treble (Tone) 8000.0 Hz
Filter Parameter
Frequency
Tone (Boost/Cut)
Q (Parametric EQ only)
Slope (HP & LP filters only)
<Click+hold+dragging>
Parameter 1
Boost/Cut: 0.0 dB
Slope: 6 dB
Slope: 6 dB
Boost/Cut: 0.0 dB
Boost/Cut: 0.0 dB
Settings Range
20 Hz to 20 kHz
-24 dB to +24 dB
0.707 to 15.000
1st Order (6 dB) and 2nd Order (12 dB)
DMP 64 • Software Control
the handle horizontally
Parameter 2
Q: 1.0
N/A
N/A
Slope: 6 dB
Slope: 6 dB
34