Extron electronics DMP 64 User Manual page 63

Calibrating Loudness
The user can fine-tune the amount of loudness compensation using the compensation
adjustment slider and adjusting "by ear," or by measuring SPL levels in a particular room,
then using the slider to adjust the loudness filter relative to the SPL of the room and
system gain structure.
Before calibrating loudness, set up the system gain structure (see
Levels on page 88). A pre-recorded track of pink noise or pink noise from a signal
generator is preferable for this purpose. Program material can also be used (using familiar
material is recommended).
If using a signal generator, set it to output -10 dBu. Tthen set the input gain of the
DSP Configurator so the input meter reads -20 dBFS. If using a recorded source, the
pink noise should be recorded at -20 dBFS and the player output level setting control set
to maximum, or 0 dB of attenuation. For program material, set the input level to meter at
approximately -15 dBFS, with peaks safely below 0 dBFS.
Unmute the mix-point from the pink noise source to the output connected to the room
amplifier being calibrated. With the basic gain structure previously set up, loudness can be
calibrated using an SPL meter or by ear. Loudness can also be set using an SPL meter,
then fine-tuned by ear.
To calibrate loudness, use a sound pressure level meter set to "C" weighting:
1. Set the Loudness processor to
2. Place the meter in an average (but somewhat prominent) listening location.
3.
Generate pink noise, or start the program material playback.
4. Measure the SPL in the room.
5. In the loudness dialog, adjust the slider until the value in the
the reading on the SPL meter.
NOTE: Theoretically, calibration can be performed with the output channel volume
and post-mixer gain level set to any comfortable listening level. But a relatively
loud volume (well above the ambient noise in the room) that can be easily
measured is preferred.
Loudness is now calibrated. Disengage
Alternate method to calibrate loudness:
1. Set up the procedure using step 1 through 3 of the previous procedure.
2. Set the compensation adjustment slider to its default center position
3. Set the output channel volume fader to 0 dB (100% volume),
4. Adjust the amplifier until the SPL meter reads 90 dB.
Loudness is now calibrated. This method works if 90 dB is an acceptable volume limit for
the room.
Setting Loudness "By Ear"
When setting loudness by ear, it is essential the system gain structure be set up first. Sit in
an average (but somewhat prominent) listening location.
1. Set the loudness processor to
2. Set the output volume fader in the DSP Configurator to a relatively quiet listening level.
Filter compensation from the loudness processor is most prominent at low listening
levels. Use familiar program material set to the levels described earlier.
( button red).
Bypass Bypass
to hear the compensation.
Bypass
.
Bypass
DMP 64 • Software Control
Optimizing Audio
readout box matches
SPL
57