Extron electronics DMP 64 User Manual page 130

DHCP Selection
The selection directs the device to ignore any entered IP addresses and obtain
DHCP On
its IP address from a Dynamic Host Configuration Protocol (DHCP) server (if the network
is DHCP capable). The
DHCP Off
administrator for additional information on your network.
IP Address Field
The field contains the IP address encoded in the flash memory of the
IP Address
connected device.
Valid IP addresses consist of four 1-, 2-, or 3-digit numeric subfields separated by dots
(periods). Each field can be numbered from
digits total per field, are optional. Values of
The factory-installed default address is 192.168.254.254, but if this conflicts with other
equipment at the installation site, change the IP address to any valid value.
NOTE: IP address changes can cause conflicts with other equipment. Only local
system administrators should change IP addresses.
Gateway IP Address Field
The
Gateway IP Address
be used if the device and the mail server are not on the same subnet.
The gateway IP address has the same validity rules as the system IP address.
Subnet Mask Field
The field is used to determine whether the device is on the same subnet as
Subnet Mask
the mail server when you are subnetting.
MAC Address Field
The Media Access Control (MAC) address is hardcoded in the device and cannot be
changed.
Firmware Field
The Firmware field displays the current firmware version being used by the device.
Model Field
The Model field displays the Extron model number of the device.
Part Number Field
The Part Number field displays the Extron Electronics part number of the device.
selection turns DHCP off. Contact the local system
through
000
and above are invalid.
256
field identifies the address of the gateway to the mail server to
. Leading zeroes, up to three
255
DMP 64 • HTML Operation 124