5.
If RS-232 is selected in step 3:
a.
Click the
com port
the rear panel RS-232 port.
b.
Check the baud rate displayed in the Com Port selection window. If the baud
rate does not match the device's rate, click the
select the desired baud rate. The default is 38400.
c.
Click OK.
The Synchronize with Device dialog box (see figure 53 on page 79) appears.
Proceed to step 7.
6.
If USB is selected in step 3:
a.
Click the
USB Device
, if
device
DMP 64
b.
Click
.
OK
The
Synchronize with Device
Proceed to step 7.
drop-down list and select the PC comm port connected to
drop-down menu and select
is not available),
dialog box (see figure 53) appears.
drop-down menu and
Baud Rate
(or
DMP 64
Extron USB
DMP 64 • Software Control
78