Table of Contents
Advertisement
5. Getting Started
5.5.1
Common Address
What is Common Address 0?
Every projector has a Common Address default set to '0', when the RCU is set to address '0', every projector, without exception will
listen to the commands given by this RCU.
When to use Common Address 0?
•
Since the RCU is default set to address '0', this is used by default to control the projector in a single projector setup.
•
The Common Address is used to control multiple projectors using only a single RCU.
When to use Common Address 1?
Most RCU's used by other electronic equipment are set to address '0', to disable the interference of other RCU's the Common
Address of the projector(s) can be set to '1'. When the projector's RCU is set to address '1', every projector, without exception will
listen to the commands given by this RCU.
How to set the Common Address?
See 'Change Common Address' in the chapter 'Service Mode'.
5.5.2
Projector Address
When to use the Projector Address?
To control a separate projector in a multiple projector setup.
What is the Projector Address?
Each projector can be set to an individual Projector Address, this can be set between '0' and '255'.
In a Linked CLO and/or Dynacolor™ setup a maximum of 14 projectors can be linked, all projectors must have
a different projector address between 0 and 13 and all projectors must have the same baudrate.
Projector Address
0–9
0–255
Regardless of the Projector Address, the projector will still respond to a RCU set to address '0' or '1' through
the Common Address.
How to set the Projector Address?
See 'Change Projector Address' in chapter 'Service Mode'.
5.5.3
RCU Address
The RCU Address can be any digit between '0' and '9'.
How to set the RCU Address?
1. Press the recessed Address key with a pencil. (image 5-10)
The Projector Address for every projector in the room will be displayed as a 3 digit code in a text box on the screen.
2. Enter the RCU Address by pressing a single digit key, within 5 seconds after pushing the address key.
Note: If the Projector Address displays '003' press the digit key 3 on the RCU. Do not enter the 3 digit code '003', this will set
the RCU to address '0'.
Note: If no digit is entered within 5 seconds the RCU will return to the default '0' address.
36
Controlled by
RCU
Computer (IBM PC or compatible, Apple, ...)
R5976781 TRACE+ 14/09/2004
Advertisement
Table of Contents
