Shift; Transport Delay - Barco Trace+ R9040341 Owner's Manual

6.5.7.6 Shift

What can be done with the Shift adjustment ?
With Shift adjustment it is possible to shift the whole image.
How to Start up Shift adjustment ?
1. Push the cursor key ↑ or ↓ to highlight Shift in the Edit menu. (menu 6-89)
2. Press ENTER to select.
The Geometry Distortion menu will be displayed. (menu 6-90)
GUIDED GEOMETRY MAP
COARSE
LINEARITY
FINE
SHIFT

TRANSPORT DELAY

BLANKING/SOFT EDGE
RESET
Select with ↑ or ↓
then <ENTER>
<EXIT> to return
Menu 6-89
How to use the Shift adjustment ?
1. Push the cursor key ↑ or ↓ to select Pixel x = 0 in the Geometry Distortion menu. (menu 6-91)
2. Push the cursor key ← or → to shift the whole image in a horizontal way.
3. Push the cursor key ↑ or ↓ to Pixel y = 0 in the Geometry Distortion menu. (menu 6-92)
4. Push the cursor key ← or → to shift the whole image in a vertical way.
5. Use the subpixel selections to fine shift the whole image.
6. Press EXIT to return to the Guided Geometry Map menu.
GEOMETRY DISTORTION
shift
pixels x = 0
y = 0
subpixels x = 0
y = 0
Menu 6-91
6.5.7.7 Transport Delay
What can be done with the Transport Delay
The first image data the projector receives from the Image Generator is the start of the first active line. However when a top side
bow pre-distortion is used, the first image data the projector needs is the image information that is halfway that first active line, to
gather all this information before projecting it on the screen, an adjustable Transport Delay is applied on the received image data.
R5976781 TRACE+ 14/09/2004
GEOMETRY DISTORTION
shift
pixels x = 0
y = 0
subpixels x = 0
y = 0
Menu 6-90
GEOMETRY DISTORTION
shift
pixels x = 0
y = 0
subpixels x = 0
y = 0
Menu 6-92
6. Random Access
87