Forced Asynchronous - Barco Trace+ R9040341 Owner's Manual

6. Random Access
6.6.7

Forced Asynchronous

What is Synchronous Mode?
When the IG provides a signal within the range from 96Hz to 108Hz, the projector will run Synchronous with the IG, this will give the
best result when projecting moving images.
What is Asynchronous Mode?
If the IG provides a signal that is not in the Synchronous Range (=96Hz to 108Hz), the projector will automatically run in Asyn-
chronous Mode, the image will be displayed by the projector at 120Hz.
If the input is a Stereo Source and the frequency is in a range from 48Hz to 60 Hz, the image will be displayed
by the projector at 120Hz.
What is Forced Asynchronous Mode (What can be done)?
When projecting a non-moving image (e.g. CAD design) with an IG providing a signal within the range from 96Hz to 108Hz, the best
result is achieved by projecting the non-moving image in the Asynchronous Mode.
By using the Forced Asynchronous menu, the projector is forced into the Asynchronous Mode, giving the best result when projecting
an non-moving image.
How to Activate Forced Asynchronous?
1. Push the cursor key ↑ or ↓ to highlight Forced Asynchronous. (menu 6-146)
2. Press ENTER to toggle between [Yes] or [No].
Yes The Projector will always run in Asynchronous Mode, projecting the image at 120Hz.
No When the IG provides a signal within the range from 96Hz to 108Hz, the projector will run Synchronous with the
IG, if not the Projector will run in Asynchronous Mode (=120Hz).
3. Press EXIT to return to the Stereo Options menu.
STEREO OPTIONS
STEREO PHASE
INVERT STEREO [YES]
MASTER CHANNEL [LEFT]
STEREO MODE [ACTIVE]
DARK TIME
FORCED ASYNCHRONOUS [NO]
WARNING
All projectors in the chain
must have the same setting
for Asynchronous Mode !
Select with ↑ or ↓
then <ENTER>
<EXIT> to return
Menu 6-146
112 R5976781 TRACE+ 14/09/2004