Table of Contents
Advertisement
F3
F2
F4
F1
F5
ADJ
EXIT
ENTER
PAUSE
TEXT
PHASE
9
0
SHARPN
7
8
TINT
5
6
COLOR
3
4
BRIGHTN
1
2
CONTR
TREBLE
BALANCE
BASS
VOL
Image 5-2
Standby key on the RCU
Lamp run time indication
The total lamp runtime for a safe operation is maximum 500 (Typical) or 1000 (Maximum) hours, do not use the lamp any longer.
Operating the lamp longer than 500 (Typical) or 1000 (Maximum) hours may damage the projector.
When the maximum lamp runtime hours is reached, the following warning will be displayed, from then on, each time the projector is
started up, this warning will be displayed.
Remaining
Lamp run time
20h
Image 5-3
Press ENTER to remove this warning.
Always replace with the same type of lamp, call a BARCO authorized service technician for this lamp replacement.
Lamp Light Output Indication
When starting up the projector, the center lumens measurement is performed, when the lamp light output is lower than 50 % of the
initial value, the lamp light output warning will be displayed.
WARNING
Lamp run time is X hours
The light output of the lamp
is less
than 50% of its initial value.
It is advisable to replace the
lamp
before damage occurs.
<ENTER> to confirm
Menu 5-1
Press ENTER to remove this warning.
5.3.2
Switching to Standby
How to Switch to Standby?
1. Press Standby to Switch the projector to Standby.
When the projector is running and you want to go to standby, press the standby key for 2 seconds until the
message 'Saving data, please wait' is displayed. Do not press any longer on the standby key otherwise the
projector will restart.
R5976781 TRACE+ 14/09/2004
5. Getting Started
31
Advertisement
Table of Contents
