Basic Soft Edge Shape Set Up - Barco Trace+ R9040341 Owner's Manual

6. Random Access

6.5.7.9.7 Basic Soft Edge Shape Set up

The following procedures will adjust the Shape of a basic Electronic Soft Edge set up with 2 projectors and
a 12.5 % overlap zone, apply the same procedures for every Electronic Soft Edge you want to create in a
multi-projector system.
Image 6-46
Basic Electronic Soft Edge set up
Be sure the Soft Edge Active mode is set to [ON] for both projectors.
Setting up the Shape for Projector 1
1. Use the combination of ENTER and the cursor key ← or → to select right all. (menu 6-112)
2. Push the cursor key ↑ or ↓ to select % of image. (menu 6-113)
3. Push the cursor key ← or → to coincide the right side of the image of Projector 1 with the center of the overlap area. (image 6-47)
4. Use the subpixel selections for fine adjustments.
SHAPE
right all
% of image = 0
%% of image = 0
Menu 6-112
96
SHAPE
right all
% of image = 0
%% of image = 0
Menu 6-113
R5976781 TRACE+ 14/09/2004