Table of Contents
Advertisement
Projector address
Why a projector address ?
As more than one projector can be installed in a room, the separate projectors should be separately addressable with a RCU or a
computer. So each projector has its own address.
Set up an individual projector address
The set up of a projector address can be done via the software.
See 'Change Projector Address' in Chapter 'Service Mode'
How to control the projector or projectors ?
The projector's address may be set to any value between 0 and 255 which can be set in the Service Mode.
When the address is set, the projector can be controlled now with:
- the RCU for addresses between 0 and 9.
- the Computer, e.g. IBM PC (or compatible), Apple MAC, etc. for addresses between 0 and 255.
Note : A projector will respond to a RCU set to the common address ('0' or '1') regardless of what address is set in the projector itself.
Common address
Every projector has a common address '0' or '1'. The choice between '0' and '1' can be selected in the Service mode.
Before using the RCU
The RCU is default programmed with address 0 or 1, 'common address'. With that 'common address' programmed into the RCU, every
projector, with the same common address set up, will listen to the commands given by this RCU. If it is necessary to control a specific
projector, than enter the projector address into the RCU (only when that address is between 0 and 9). The projector with the
corresponding address will listen to that specific RCU.
Display the projector address on the screen
Press the ADDRESS key (recessed key on the RCU) with a pencil. The projector's address will be displayed in a 'Text box' (menu 1).
This text box disappears after a few seconds.
To continue using the RCU with that specific address, it is necessary to enter the same address with the digit buttons (address between
0 and 9) within 5 seconds after pushing the address key. For example : if the Address key displays projector address 003, then press
"3" digit button on the RCU to set the RCU's address to match the projector's address. Do not press 003 digits. This will address the
remote control to '0' and control all projectors in the room.
If the address is not entered within 5 seconds, the RCU returns to its default address (zero address) and control all projectors in the
room.
How to program an address into the RCU ?
Press the ADDRESS key (recessed key on the RCU) with a pencil and enter the address with the digit buttons within 5 seconds after
pushing the address key. That address can be any digit between 0 and 9.
Controlling the projector
5976419 BARON 908 04122001
PROJECTOR ADDRESS
001
Getting started
3 - 5
Advertisement
Table of Contents
