Table of Contents
Advertisement
How to change the Slot Selection?
1. Push the cursor key ↑ or ↓ to highlight Slot Selection.
2. Press ENTER to toggle between [AUTOMATIC] or [MANUAL].
Note: The default setting for the Slot Selector is [AUTOMATIC].
[AUTOMATIC]
[MANUAL]
Possible results for the fixed inputs (1&2)
Source
RGB analog
DVI
What if a switcher is connected to the projector?
If a RCVDS (switched on) or VS05 is connected to the projector, it will be also indicated on the menu by adding +800 peripheral.
If no 800 peripheral indication is made on the menu, there are still two possibilities, no RCVDS or VS05 connected or RCVDS is
switched off.
When a 800 peripheral is connected to the projector, the input slots are not accessible with the cursor key to toggle their function.
7.4 No Signal
Overview
•
Starting Up No Signal
•
Changing the Background Color
•
Changing the Shutdown Setting
•
Changing the Shutdown Time Setting
7.4.1
Starting Up No Signal
How to Start Up No Signal?
1. Push the cursor key ↑ or ↓ to highlight No Signal. (menu 7-5)
2. Press ENTER to select.
The No Signal menu will be displayed. (menu 7-6)
INSTALLATION
INPUT SLOTS
NO SIGNAL
LENS
MENU POSITION [CENTER]
800-PERIPHERAL
CONFIGURATION
OSD COLOR
INTERNAL PATTERNS
Select with ↑ or ↓
then <ENTER>
<EXIT> to return
Menu 7-5
7.4.2
Changing the Background Color
What can be done?
When no source signal is present a Blue or Black background color will be displayed.
R5976781 TRACE+ 14/09/2004
The projector will scan the inputs one by one, if one source is found, this source will
be projected, if different sources are found the priority is as follow (Input 1: 5 Cable
Input, Input 2: Computer).
The user will select the desired input.
Indication
RGB-SS [CS OR HS&VS] : Separate Sync is Composite Sync or Horizontal & Vertical Sync
RGB-SOG : Sync On Green
DVI
NO SIGNAL
COLOR [BLUE]
SHUTDOWN [OFF]
SHUTDOWN TIME 0 MIN
Select with ↑ or ↓
then <ENTER>
<EXIT> to return
Menu 7-6
7. Installation Mode
115
Advertisement
Table of Contents
