6. Random Access
6.5.7.9.3 Soft Edge Start up
How to Start up Soft Edge ?
1. Push the cursor key ↑ or ↓ to highlight Blanking/Soft Edge menu. (menu 6-107)
2. Press ENTER to select.
The Blanking/Soft Edge menu will be displayed. (menu 6-108)
GUIDED GEOMETRY MAP
COARSE
LINEARITY
FINE
SHIFT
TRANSPORT DELAY
BLANKING/SOFT EDGE
RESET
Select with ↑ or ↓
then <ENTER>
<EXIT> to return
Menu 6-107
6.5.7.9.4 Switching on the Soft Edge
How to switch on the Soft Edge?
The Soft Edge is switched On/Off inside the Windowing menu.
The Active [On] or [Off] menu item is grayed out an will only show the current soft edge status.
[OFF]
[ON]
6.5.7.9.5 Soft Edge Shape Start up
What can be done with the Soft Edge Shape menu ?
Before creating a soft edge, an overlap zone is created, the shape of this overlap zone is fully adjustable, within this menu the shape
of the blending zone is aligned with the shape of the overlap zone.
How to Start Up the Soft Edge Shape menu ?
1. Push the cursor key ↑ or ↓ to highlight Shape in the Blanking/Soft Edge menu. (menu 6-109)
2. Press ENTER to select.
The Shape menu will be displayed. (menu 6-110)
BLANKING/SOFT EDGE
ACTIVE [ON]
BLANKING
SOFT EDGE
Select with ↑ or ↓
then <ENTER>
<EXIT> to return
Menu 6-109
94
BLANKING/SOFT EDGE
ACTIVE [OFF]
BLANKING
SOFT EDGE
Switch ON/OFF
in Windowing Menu
Select with ↑ or ↓
then <ENTER>
<EXIT> to return
Menu 6-108
Soft Edge is disabled
Soft Edge is enabled
SHAPE
top left
% of image = 0
%% of image = 0
Menu 6-110
R5976781 TRACE+ 14/09/2004