Table of Contents
Advertisement
8.9.5
Hot Key
How to Change the Hot Key Setting?
1. Push the cursor key ↑ or ↓ to highlight Hot Key. (menu 8-25)
2. Press ENTER to toggle the Hot Key Setting [ON] or [OFF].
[ON]
The TEXT key on the RCU is used to display or to remove the Barco Logo with one single push on this key
(only in operational mode)
[OFF]
No key on the RCU is used to display the Barco Logo
3. Press EXIT to return to the Service menu.
BARCO LOGO
STATUS [OFF]
BACKGROUND [OFF]
SHIFT
HOT KEY [OFF]
Select with ↑ or ↓
<ENTER> to toggle/select
<EXIT> to return
Menu 8-25
8.10 Preset Input Balance 1
C
AUTION
How to Start Up Preset Input Balance?
1. Push the cursor key ↑ or ↓ to highlight Preset Input Balance 1. (menu 8-26)
2. Press ENTER to select.
The following warning will be displayed: (menu 8-27)
Preset input balance is reserved to qualified service personnel. If you are not qualified, press EXIT to return to the Service menu.
SERVICE
BARCO LOGO
PRESET INPUT BALANCE 1
PRESET INPUT BALANCE 2
ELECTRONIC CONVERGENCE
DIAGNOSIS
DYNACOLOR
Select with ↑ or ↓
then <ENTER>
<EXIT> to return
Menu 8-26
8.11 Preset Input Balance 2
C
AUTION
R5976781 TRACE+ 14/09/2004
:
Changing these settings may seriously affect the performance of the projector.
WARNING
PRESET INPUT BALANCE
is reserved to
qualified
service personnel
<ENTER> to continue
<EXIT> to cancel
Menu 8-27
:
Changing these settings may seriously affect the performance of the projector.
8. Service Mode
133
Advertisement
Table of Contents
