Lamp Menu; Starting Up The Lamp Menu - Barco Trace+ R9040341 Owner's Manual

8. Service Mode
How to Change Baudrate PC?
1. Push the cursor key ↑ or ↓ to highlight Change Baudrate PC. (menu 8-11)
2. Press ENTER to select.
The Change Baudrate PC menu will be displayed.
The actual baudrate will be highlighted. (menu 8-12)
3. Push the cursor key ↑ or ↓ to highlight the desired Baudrate.
4. Press ENTER to accept the selected Baudrate.
SERVICE
IDENTIFICATION
CHANGE PASSWORD
CHANGE PROJ. ADDRESS
CHANGE BAUDRATE PC
LAMP
MORE ...
Select with ↑ or ↓
then <ENTER>
<EXIT> to return
Menu 8-11

8.8 Lamp Menu

Overview
•

Starting Up the Lamp Menu

• Constant Light Output (CLO)
• Linked CLO
• Lamp Mode
• Target CLO Lumens
8.8.1 Starting Up the Lamp Menu
What can be done?
All information about the lamp is stored inside the lamp house and can be displayed via the projector software, no information can
be changed.
Following Lamp Information can be consulted:
Serial number
Article number
Run time
Remaining run time
Number of strikes
Z-axis
Table 8-1
Lamp Information
Following Lamp Settings can be changed:
• Constant Light Output
• (Lamp) Mode
128
CHANGE BAUDRATE PC
115200
57600
38400
19200
9600
9600
4800
1200
Select with ↑ or ↓
<ENTER> to accept
<EXIT> to return
Menu 8-12
Unique serial number of the lamp
Article number of the lamp
Total time the lamp is used in this projector
Time left before the lamp must be replaced. Using the lamp longer than the maximum run
time may damage the projector
Total times the lamp is started up
Indication to adjust the Z-axis of the lamp, for more information see 'Re-adjusting the lamp
position in the lamp casing' in chapter 'Installation Guidelines'
R5976781 TRACE+ 14/09/2004