Edit Warp2 File - Barco Trace+ R9040341 Owner's Manual

Field select
Vertical refresh
[sync/async]
Vertical Sync Polarity:
[leading] or [trailing]
6.3.9

Edit WARP2 File

What can be done?
This item is only available when running in Stereo Mode.
How to Start Up Edit WARP2 File?
1. Push the cursor key ↑ or ↓ to highlight Edit WARP2.
2. Press ENTER to select.
The Edit file adaptation menu will be displayed. (menu 6-16)
EDIT FILE
Filename Scr resolution
xga_60.s01 1 1024x768
xga_60.c01 1 1024x760
xga_60.c02 1 1024x760
xga_60.c03 1 1024x760
----------------------------
Active file : xga_60.c04
Select with ↑ or ↓ , →
<ENTER> to accept
<EXIT> to return
Menu 6-16
R5976781 TRACE+ 14/09/2004
Default [both]
The field select is only used for interlaced images. One frame of an interlaced image contains two
fields, an even and an odd field. The choice exists to project [both] fields on the screen or only the
[even] or [odd] field.
Use the ENTER key to toggle between [both], [even] and [odd].
If the active Stereo Compatibility Option is installed, the field select parameter will be changed
into a [left] and [right] selecting parameter which will be selectable for stereo files. This setting
will then be saved in the active image file.
The way of updating the image information on the DMD panels. Not available for PAL-NTSC-SECAM
sources. Where this option will be displayed in gray.
• For sources with a vertical frequency up to 62 Hz : the vertical refresh rate is the same as the
vertical frequency of the incoming source. This is a necessity to project moving images without
'motion artifacts'. For stationary images with a vertical frequency up to 62 Hz it is still possible to
use asynchronous refresh.
• For sources with a vertical frequency higher than 62 Hz : the vertical refresh is different than the
vertical frequency of the incoming source. Synchronous refresh cannot be used.
The vertical refresh can be synchronized with the leading sync edge or trailing sync edge. Default on
[leading]. Toggling to [trailing] is only necessary for special applications where the trailing edge of the
sync signal has to be taken as a reference. Use the ENTER key to toggle between [leading] or [trailing]
6. Random Access
47