Connections; Ac Power; Ac Power Cord Connection; Power Voltage - Barco Baron 908 R9040060 Owner's Manual

2

CONNECTIONS

AC Power

AC Power cord connection

Use the supplied power cord to connect your projector to the wall outlet. Plug the female power connector into the male connector
at the front side of the electronic block.
OFF ON
POWER MAINS
REMOTE
image 2.1
AC Power cord connection

Power voltage

The power voltage is autoranging between 100V (-10%) and 240V (+6%).

Switching on/off

The projector is switched ON and OFF using the power (mains)switch.
Pressed : ON
Not pressed : OFF
OFF ON
POWER MAINS
REMOTE
image 2.2
Power switch
Stand by indication lamp :
No light up : projector switched off
Green color : projector in Operational mode
Red color : projector is in Standby mode.
When switching on with the power switch, the projector can start now in :
1 Operational mode (picture displayed)
2 Stand by mode
The way of start up depends on the 'Power up' setting in the service mode.
5976419 BARON 908 15032003
800 periphals
COMM. PORT PORT 3
RS 232 OUT
IR RS 232 IN
800 periphals
COMM. PORT PORT 3
RS 232 OUT
IR RS 232 IN
See installation instructions before connecting to the supply.
Voir la notice d' installation avont de raccorder au réseau.
R G B
DEFOCUS
Comp / H-Sync V-Sync
PORT 4 / 5
See installation instructions before connecting to the supply.
Voir la notice d' installation avont de raccorder au réseau.
R G B
DEFOCUS
Comp / H-Sync V-Sync
PORT 4 / 5
This device complies with part 15 of the FCC rules.
Operation is subject to following two conditions (1).
This device may not cause harmful interference,
and (2) this device must accept any interference that
may cause undesired operation.
X-POS Y-POS
OFF - ON OFF - ON
75 Ohm 75 Ohm
PORT 2 PORT 1
This device complies with part 15 of the FCC rules.
Operation is subject to following two conditions (1).
This device may not cause harmful interference,
and (2) this device must accept any interference that
may cause undesired operation.
X-POS Y-POS
OFF - ON OFF - ON
75 Ohm 75 Ohm
PORT 2 PORT 1
Connections
green: operation
red: standby
PROJECTOR MODE
green: operation
red: standby
PROJECTOR MODE
2 - 1