Printronix P7000 User Manual page 280

Chapter 7
Diagnosing Problems
Table 13. LCD Message Troubleshooting Table
Displayed Message
ILLGL OPR ACCSS*
INCOMPAT E-NET
Remove NIC
INTAKE FAN FAULT
INTERRUPT UNUSED
VECTOR 00
INVALID ACTIVATE
INVALID COMMAND
LO DRV. SHORT *
LOAD PAPER
LOADING PROGRAM
FROM PORT XX%
LOADING PROGRAM
INTO FLASH
280
Can User
Explanation
Correct?
No Illegal Operand
Accessed. Firmware
error on controller board.
Yes Incompatible network
interface card (NIC) is
installed.
Yes Sensors cannot detect
current in fan circuit.
No The controller board
receives an interrupt it
does not understand. The
problem can be created
by electrical noise, by a
software problem, or by a
hardware problem.
No Printer detects a twinax
protocol communication
error.
No Printer detects a twinax
protocol communication
error and reports the
error.
No Lower Driver Short.
Circuit(s) on the hammer
bank or in the hammer
bank power cable
shorted to ground.
Yes Printer is out of paper.
No Status message: the new
emulation program is
loading into printer RAM.
XX% indicates how much
of the program has
loaded.
No The printer has deleted
the previous program
from flash memory and is
loading the new program
into flash memory.
Solution
Contact your authorized service
1
representative.
Install a compatible NIC to the
printer then reboot. If this message
still appears, contact your
authorized service representative.
Cycle power. If the message
appears, press CLEAR. If the
message does not clear, contact
your authorized service
1
representative.
Cycle power. If this message
occurred once and never again, you
can ignore it. If the message
reappears or appears consistently,
contact your authorized service
1
representative.
Contact your authorized service
1
representative.
Contact your authorized service
1
representative.
Contact your authorized service
1
representative.
Load paper and press CLEAR.
No action is required.
No action is required.
1