P-Series Emulation (With Lg) - Printronix P7000 User Manual

Chapter 4
LinePrinter Plus Emulation (With PCL-II)

P-Series Emulation (With LG)

Printer
Protocol
(from page 141)
P-Series
Control Code
06
8.0 LPI*
10.3 LPI
6.0 LPI
P-Series
SFCC
1*
(0-7F hex)
Control Code 06
Control Code 06 defines the function of ASCII code hex 06 (ACK). You can
select an alternate line spacing of 6, 8, or 10.3 LPI.
Control Code 08
Control Code 08 defines the function of ASCII code hex 08 (BS). You can
define the code to output the following character:
•
Elongated (default).
•
Backspace.
Define CR Code
This option controls the action of the printer when it receives a Carriage
Return code (hex 0D) from the host computer. If this feature is enabled, each
time the printer receives a carriage return, it inserts an additional Line Feed
code (hex 0A) into the data stream. Do not use this feature if the host
computer sends Line feeds to the printer.
•
CR = CR (default). Does not insert an extra line feed after each carriage
return.
•
CR = CR + LF. Inserts an extra line feed after each carriage return. The
next print position will be print position 1 of the next line.
148
Control Code Define CR
08 Code
Elongated* CR = CR*
Backspace CR = CR + LF
EVFU Select Alt. Set
80-9F
Enable* Control Code*
Disable Printable
Auto LF Overstrike
Disable* Enable*
Enable Disable
Character SFCC d
Set Command
(see page 154) Even dot plot*
Double high
* = Factory Default
Define LF
Code
LF = CR + LF*
LF = LF