Cancel Key; Power Saver Time; Pwr Save Control; Ret. Status Port - Printronix P7000 User Manual

Chapter 4
ADVANCED USER - P7000HD

Power Saver Time

The time interval you specify for this parameter sets the amount of idle time
before the printer goes into Power Saver mode. When Instant is chosen, the
printer goes into Power Saver mode as soon as it is able to stop the shuttle
properly. The time allotted to perform this function depends upon the shuttle
timeout value which can be set in the menu.
NOTE: Power Saver Mode will not be shown on the control panel even

Pwr Save Control

Allows you to enable or disable the Power Save (Energy Star) mode.
•
Enable (default). Allows you to enable the Power Save (Energy Star)
mode.
•
Disable. Allows you to disable the Power Save (Energy Star) mode.

Cancel Key

•
Disable (default)
•
Enable. The CANCEL key may be used to clear all data in the print buffer
without printing any of the data.

Ret. Status Port

This option selects the port for the Return Status Commands (i.e., ~STATUS
(PGL) and ~HS (ZGL)) to send the status data back to the Host.
The options are Automatic (factory default), Serial, E-NET Stat Port,
IEEE 1284, Disable, and E-NET Data Port.

Set Lock Key

Normally, to lock or unlock the printer menu, the UP and DOWN keys are
pressed at the same time. The Set Lock Key parameter lets you choose
different keys to lock or unlock the printer menu. You may choose almost any
group of keys as the new lock and unlock keys. You cannot use the ENTER
key or any key combinations which are already used for another function.
There is no limit to how many keys you can select.
To set the new lock key, follow these steps:
1. Work your way through the configuration menu until the display reads
"Set Lock Key" (follow the menu structure on page 225).
2. Press ENTER. The display reads, "Select a new lock key."
3. Press the combination of keys you want to be the new lock key. Make
sure you press all keys selected at the same time.
4. If the selection is valid, the display will read, "Enter the new lock key
again." If the selection is invalid, the display will read, "Invalid key
selection." Return to step 2 and start over.
230
though the function still exists. Sending a print job to the printer will
turn off Power Saver mode.