Printronix P7000 User Manual page 261

Table 13. LCD Message Troubleshooting Table
Displayed Message
B12 ERROR: Yes
PROGRAM MISSING*
B13 ERROR: NOT No
COMPATIBLE*
B19 ERROR: DC No
RETURNED*
B20 STATUS :00% No
DOWNLOAD MODE
B21 STATUS: No
PRINTER RESET
B22 ERROR: No
DECOMPRESS SIZE*
B23 ERROR: No
DECOMPRESS
CKSUM*
B30 STATUS: N/A
INITIALIZING...
B35 STATUS: N/A
WAITING FOR EC
STATUS
Can User
Explanation
Correct?
The printer does not see
a program in flash
memory.
Attempting to download a
program that is not
compatible with the
printer.
The message indicates
an incorrectly assembled
and tested machine.
Status message
informing the operator
that software is being
downloaded. Percentage
figure indicates
approximate amount
loaded into the printer.
Status message
informing the operator
that the printer is
undergoing a system
reset.
FLASH memory has not
passed boot initialization
tests.
FLASH memory has not
passed boot initialization
tests.
Status message: the
printer is running its
initialization routines after
startup and successful
memory tests.
Status message: the DC
on the controller board is
waiting for
communication with the
EC. If this message does
not clear witin a few
seconds there is an
electrical or electronic
problem on the controller
board.
Fault Messages
Solution
There is no program in printer
memory. Download an emulation.
Cycle power to see if the message
clears, if not, contact your
authorized service representative.
Cycle power to see if the message
clears, if not, contact your
authorized service representative.
No action is required.
No action is required.
Cycle power to see if the message
clears, if not, contact your
authorized service representative.
Cycle power to see if the message
clears, if not, contact your
authorized service representative.
No action is required.
Cycle power to see if the message
clears, if not, contact your
authorized service representative.
1
1
1
1
1
261