Configuring The Emulation With The Control Panel; Igp/Vgl Submenu - Printronix P7000 User Manual

Configuring The Emulation With The Control Panel

You can select VGL default parameters directly from the control panel or by
control codes as explained in the IGP/VGL Programmer's Reference Manual.
The VGL parameters are described on the following pages. Parameters
marked with an asterisk (*) indicate the default value. The printer must be
offline to enter the configuration structure.
IMPORTANT
BEFORE you reconfigure the IGP/VGL, print a configuration sheet to see
all of the current settings.
Pressing an invalid key to enter a parameter value may move you to another
level in the configuration menu or exit the menu completely.

IGP/VGL Submenu

EMULATION
(from page 106)
IGP/VGL
SFCC &
Pwrup
VGL SFCC
5E*
Power-up ^X
Disable*
Enable
Power-up ^F
Disable*
Enable
Power-up ^PY
Disable*
Enable
Font Set
(see page 207)
Configuring The Emulation With The Control Panel
LPI Graphics
Options
6* (see page 194)
7
8
9
10
PI Control Prt to
Emulate
Printer PI Disable*
Disable* MVP/MVP 150B
Enable L150
Host PI P3040
Disable* P6000
Enable P9000
Max PI 16
Enable*
Disable
* = Factory Default
Error Ignore/DB8
Handling Setup
Error Msgs Ignore Chars
Enable* Disable*
Disable Char 1
Error Markers Char 2
Enable* Char 1&2
Disable Ignore Ch#1
Offpage Errors 0* (0-255)
Disable* Ignore Ch#2
Enable 0* (0-255)
Barcode Errors Data Bit 8
Enable* Enable*
Disable Disable
193