Printer Select; Esc D Command - Printronix P7000 User Manual

Printer Select

•
Disable (default). Ignores the ASCII DC1 and DC3 control codes.
•
Enable. Disables the printer when a DC1 control code is received, and
enables the printer when a DC3 control code is received.
Alt. Set 80-9F
•
Control Code (default). Interprets data in the range of hex 80 through
hex 9F as a control code.
•
Printable. Prints data in the range of hex 80 through hex 9F.
Character Set
Specifies a character set as shown in the
Σετ Μενυ ον παγε 160
group heading (such as European Sets) and press ENTER. Then choose the
desired set within that group (such as Roman 8) and press ENTER. Both the
group and the desired set will be starred to indicate your selection. Character
sets are shown in detail in the Character Sets Reference Manual.

ESC d command

•
Even dot plot (default). Interprets the ESC d command as even dot plot.
•
Double high. Interprets the ESC d Command as double high. Select this
option for backward compatibility.
Σεριαλ Ματριξ Χηαραχτερ
. To use one of these sets, choose the desired
Serial Matrix Emulation
159