Diagnostics - P7000; Rbn End Action - Printronix P7000 User Manual

Chapter 4

DIAGNOSTICS - P7000

RBN End Action

This menu allows the user to override the normal ribbon low warning and
ribbon out conditions.
•
Stop At RBN End (default). When this factory default option is selected
the printer displays a warning message when a ribbon low condition is
reached and display a ribbon out fault when ribbon life reaches 0%.
•
Ignore RBN End. When this menu option is selected it overrides the
ribbon low and ribbon out conditions, i.e. no warning or fault messages is
displayed and printing continues even after ribbon life reaches 0%.
However, once the ribbon life reaches an excess wear condition as
indicated by the fault message "EXCESS RBN WEAR / Install New RBN",
printing will stop and the user must install a new ribbon before printing
can resume.
NOTE: The excess ribbon wear is set below the "Lighter -10" Ribbon End
DIAGNOSTICS - P7000
DIAGNOSTICS
(from page 60)
Printer Tests Test Width
Shift Recycle* Full Width*
All E's 80 col.
E's + TOF
All H's
All Underlines
All Black
Shuttle Slow
Shuttle Fast
Shuttle Only
Phase Printer
Paperout Adj.
Burnin Test
3
Print Error Log
3
Clear Error Log
1
Adapter Test
Ethernet Test
2
Acoustics
Demo
Dice 5
Prnt Ribbon Log
Checker
Software Feature
4
Build File
SW P/N + Ver P/N of File
232
Point setting.
Paper Out
Dots
40 dots* 32 Megabytes
(4-76)
Shuttle
Type
2000s
* = Factory Default
1
If Ethernet adapter is present
2
Not available in PCL-II or LG
3
Not available in LG
4
If a Feature File exists.
System Print
Memory Statistics
On: 144.9 Hrs.
Print: 8.3 Hrs
Print Strokes:
233441
Print Lines:
28250
11 inch Pages:
614