Dataproducts Submenu - Printronix P7000 User Manual

Dataproducts Submenu

Dataproducts
(from page 74)
Data Bit 8 PI Ignored
Enable* Enable*
Disable
Disable
TOF Action Buffer Size
in K
Reset* 16*
Do Nothing
(1-16)
Data Bit 8
•
Enable (default). Allows access to the extended ASCII character set.
•
Disable. The printer interprets bit 8 of each incoming data character as a
zero, regardless of its actual setting.
PI Ignored
The PI (Paper Instruction) signal is used to control vertical paper motion.
•
Enable (default). Causes the printer to interpret the eight data lines as
DVFU commands when the PI signal is true.
•
Disable. Ignores the PI signal and treats the data as characters or control
codes.
Data Polarity
The Data Polarity parameter must be set to match the data polarity of your
host computer.
•
Standard (default). Does not expect the host computer to invert the data.
•
Inverted. Expects the data received on the data lines from the host
computer to be inverted. Ones become zeros, and zeros become ones.
Data Resp.
Polarity Polarity
Standard* Standard*
Inverted Inverted
Auto Trickle
Trickle Time
Disable* 1/4 sec*
Enable 1/2 sec
1 sec
2 sec
4 sec
8 sec
16 sec
Off
Dataproducts Submenu
* = Factory Default
Latch Data Prime Signal
On
Middle* Disable*
Trailing Enable
Leading
81