Restoring The Default Settings; Changing The Dome Address, Protocol, Parity, And Baud Rate Settings - Honeywell ACUIX User Manual

Restoring the Default Settings

Changing the Dome Address, Protocol, Parity, and
Baud Rate Settings
Document 800-05662V1 Rev A
04/11
ACUIX™ PTZ High Speed Analog Dome Installation and Configuration Guide
There are two ways to restore the default settings of the dome:
• You can restore all of the default settings except for the programmed
functions (presets, preset tours, mimic tours, privacy zones, sectors, default
functions, timed functions) by using the OSD menus.
• You can restore all of the default settings including the programmed
functions (presets, preset tours, mimic tours, privacy zones, and sectors)
by resetting DIP switch SW5-7 on the scan assembly circuit board.
To restore the default settings using the OSD:
1. Select 4 Diagnostic Options
The following message appears:
Caution: This will restore all user defined settings to their
default values. Are you sure that you want to do this? Y/N
2. Select: Y (yes) to continue, or select N (no) to cancel.
To restore the default settings using scan assembly DIP switches:
1. Locate DIP switch SW5-7 on the scan assembly circuit board (see
Figure 2-1 on page
2. Move the switch to ON to restore the factory default settings. This will delete
all user-programmed functions, including presets, preset tours, mimic
tours, privacy zones, and sectors.
3. After the factory default settings have been restored, move the switch back
to OFF to prevent unwanted deletion of user-programmed configurations.
If DIP switch SW5-8 on the scan assembly circuit board (see
page 4) is set to OFF, you can change the dome address, protocol, parity and
baud rate settings from the OSD menu. However, this is not recommended for
most installations since changing these settings can cause a loss of
communication between the controller and the dome.

6 Restore Default Settings.
4).
Figure 2-1 on
83